Hanging  Pinch Pleated Draperies
After purchasing your beautiful draperies and installing your drapery rod, it is now time to
hang them on the traverse rod.  Follow our step by step instructions to ease the burden of
hanging pinch pleated draperies on a traverse rod.  Even the most beautiful draperies will not
look good if not hung properly.
Step 1
From the top of each drapery panel insert a drapery pin
1 1/2"  down on the back side of each pleat.

Step 2
Begin hanging your pinch pleated draperies at the
master slide on your traverse rod .  The first drapery
hook will be inserted behind the arm of the master
carrier (see illustration).
Step 3
Continue placing a hook in each slide on your traverse
rod.  If there are extra slides, push them to the end of the
 traverse rod and remove.  The slides are easily
removed by pulling the end gate on the traverse rod
down and slipping them out.  Don't forget to push the
end gate up to close.   
Step 4
Pin the last pleat on your draperies to the pulley housing
on the traverse rod.  Pin the last hook on your pinch
pleated draperies  to the bracket hole on the side  of the
traverse
rod .
Buy quality Graber traverse rods here!